Ronald A. Weist
Network Engineer Candidate
Network Experience | Hardware Experience | Software Experience | Home | Network Diagrams | Scopes of Work | Internal Proposals |
Customer Scopes of Work
Intrusion Detection System | Packeteer Packetshaper | Network Sniffer |
Dial Backup Scope | Line Upgrade | Site-to-site PIX VPN Scope |
Line Upgrade Scope of Work
Logo Removed
|
Address Removed City, State Zip Removed Phone Number Removed Fax Number Removed |
|
Date
|
Line Upgrade
Scope Of Work
I.
Upgrade Hoopa
and
II.
Upgrade
Weaverville and Willow Creek to 384 Kbps.
I.
Upgrade Hoopa
and
A. This can be done on days between the Weaverville and
Willow Creek work
B. Install new CSU/DSUs on Fractional T1 units
C. Verify connectivity via Frame Relay cloud
D. Get new circuit numbers recorded on drawing and in
notes
E. Adjust to applicable channels from Telco
F. Adjust bandwidth on router if needed
G. Turn down 56K lines at both sites
II.
Upgrade
Weaverville and Willow Creek to 384 Kbps.
A. This is to be done in the late evening or early
morning
B. Verify circuit numbers and record on drawing and in
notes
C. Adjust to applicable channels from Telco
D. Adjust bandwidth on router if needed
E. Test connectivity
Customer must provide the
necessary network addressing and protocol information prior to equipment
configuration. PRE EXISTING
Customer must provide the
necessary circuit provisioning information prior to router configuration. We are working directly with the Telco on
this.
Customer must provide the
necessary information required for any software configuration. N/A
Customer is responsible for
scheduling circuit turn-up with the circuit provider. We can act as a liaison
with the circuit provider at Customer request.
Customer is responsible for
providing a sufficient space in the Computer Room for the installation of the
new equipment.
Customer is responsible for
providing a sufficient number of power outlets to run the equipment. These
outlets should be isolated from an electrical circuit that may create
electronic interference with data communications equipment.
Customer is also responsible
for providing the appropriate operating environment for these products as
described by the manufacturer of the equipment.
This Scope of Work will
guarantee network connectivity. However network functionality is not
guaranteed. Network functionality is dependant on Server and Workstation
configuration parameters that fall outside of this Scope of Work.
All work to be done within
normal business hours (Monday to Friday, 8:00am to 5:00pm). Projects requiring
labor outside of these hours will be charged at a premium overtime rate.
This Scope of Work has been agreed to and accepted by:
(Client Signature)
(Print here)
(Engineer Signature)
(Print here)